devices.esphome.io

AirGradient-DIY

AirGradient-DIY

Device Type: sensor
Electrical Standard: us
Board: esp8266

Air environment sensor from PM2.5, CO2, Temperature and Humidity from AirGradient.

Variations of the components are possible. Check your components.

If you have multiple sensor boards, you will likely need to make each sensor name unique across the boards (e.g. "1st AirGradient Temperature"), so there aren't naming conflicts.

Basic Configuration

esphome:
  name: airgradient


esp8266:
  board: d1_mini


# Enable logging
logger:


# Enable Home Assistant API
api:
  encryption:
    key: !secret api_encryption_key


ota:
  password: ""


captive_portal:


i2c:
  sda: D2
  scl: D1


uart:
  - rx_pin: D5
    tx_pin: D6
    baud_rate: 9600
    id: uart1
  - rx_pin: D4
    tx_pin: D3
    baud_rate: 9600
    id: uart2


sensor:
  - platform: sht3xd
    temperature:
      id: temp
      name: "Temperature"
    humidity:
      id: humidity
      name: "Humidity"
    address: 0x44
    update_interval: 5s
  - platform: pmsx003
    type: PMSX003
    uart_id: uart1
    pm_2_5:
      id: pm25
      name: "Particulate Matter <2.5µm Concentration"
  - platform: senseair
    uart_id: uart2
    co2:
      id: co2
      name: "SenseAir CO2 Value"
    update_interval: 60s

OLED Support

If you are using the 64x48 OLED shield that's included in the kit, you can use this config. Note that you will need to place fonts/helvetica.ttf (or another font of your choosing) in the ESPHome config directory.

This config will print all four sensor states to the display.

font:
  - file: "fonts/helvetica.ttf"
    id: helvetica
    size: 12
    glyphs: |
      !"%()+=,-_.:°0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyzµ³/


display:
  - platform: ssd1306_i2c
    model: "SSD1306 64x48"
    address: 0x3C
    lambda: |-
      // For Celsius, uncomment the below line
      // it.printf(0, 0, id(helvetica), "%.1f°C", id(temp).state);
      // For Fahrenheit, uncomment the below line
      // it.printf(0, 0, id(helvetica), "%.1f°F", (id(temp).state * 1.8) + 32);
      it.printf(0, 12, id(helvetica), "%.1f%% RH", id(humidity).state);
      it.printf(0, 24, id(helvetica), "%.0fppm", id(co2).state);
      it.printf(0, 36, id(helvetica), "%.0f µg/m³", id(pm25).state);
Edit this page on GitHub

On this page