devices.esphome.io

Mirabella Genio Wi-Fi Dimmable 9W LED CCT Downlight I002741

Mirabella Genio Wi-Fi Dimmable 9W LED CCT Downlight I002741

Device Type: light
Electrical Standard: au
Board: bk72xx

General Notes

Mirabella Genio Wi-Fi Dimmable 9W LED CCT Downlight

Mirabella Genio Wi-Fi Dimmable 9W LED CCT Downlight

This contains a Tuya Beken Chip CB2L which can be flashed with ESPHome and a USB to UART converter by soldering to the RX and TX pads on the back of the board, plus VCC and GND pins. It is not necassary to remove the CB2L chip from the unit to flash it.

It might be possible to flash (especially older units) OTA using tuya-convert. If you attempt to flash a current unit OTA, you should update this page specify if it's still possible or not.

To open the downlight you need to take the difuser out. This can be done with a sharp knife or a small screwdriver buy may leave minor damage. A suction cup might work to pull it out unharmed.

Basic Configuration

esphome:
  name: downlight
  name_add_mac_suffix: true


wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  ap:
    ssid: 'downlight'
    password: 'ap_password'


# Enable logging
logger:


# Enable Home Assistant API
api:
  encryption:
    key: !secret encryption_key


ota:
  password: 'ota_password'


# Platform
bk72xx:
  board: cb2l


# LED driver
bp5758d:
  data_pin: GPIO7
  clock_pin: GPIO8


# Individual outputs
output:
  - platform: bp5758d
    id: output_red
    channel: 1
    current: 10 # 10mA measured on unmodified unit
  - platform: bp5758d
    id: output_green
    channel: 2
    current: 7 # 7.5mA measured on unmodified unit
  - platform: bp5758d
    id: output_blue
    channel: 3
    current: 7 # 7mA measured on unmodified unit
  - platform: bp5758d
    id: output_warmwhite
    channel: 4
    current: 25 # 25mA measured on unmodified unit
  - platform: bp5758d
    id: output_white
    channel: 5
    current: 25 # 25mA measured on unmodified unit


light:
  - platform: rgbww
    name: 'downlight'
    id: 'downlight'
    red: output_red
    green: output_green
    blue: output_blue
    warm_white: output_warmwhite
    cold_white: output_white
    warm_white_color_temperature: 2700 K
    cold_white_color_temperature: 6500 K
    color_interlock: true
Edit this page on GitHub

On this page